Directions For Use :
It is a violation of Federal Law to use this product in a manner inconsistent with its labeling. Do not water the treated area to the point of run-off. Do not make applications during rain.
All outdoor applications must be limited to spot or crack-and-crevice treatments only, except for the following permitted uses:
1. Treatment to soil and vegetation around structures;
2. Application to lawns, turf, and other vegetation;
3. Applications to building foundations, up to a maximum height of 3 feet.
Other than applications to building foundations, all outdoor applications to impervious surfaces such as sidewalks, driveways, patios, porches and structural surfaces (such as windows, doors, and eaves) are limited to spot and crack-and-crevice applications, only.
SHAKE WELL BEFORE USE
LAWN FLEA AND TICK CONTROL:
To kill fleas and ticks harboring in lawns and backyards. For best results, lawn should be mowed a day or two before spraying. Spray using a slow, even sweeping motion, being sure to cover the entire lawn surface where the pets will normally frequent. Spray under ornamentals and trees, but avoid soaking young or flowering plants. Kills on contact the Ixodes scapularis tick (deer tick), which may carry Lyme disease.
Keep pets and children out of treated areas until after the spray has dried. Do not spray animals. Dogs, cats, their kennel or bedding area should also be treated with a registered flea and tick control product in conjunction with this application.
HOW TO USE THE READY-TO-SPRAY SYSTEM
1. Connect sprayer to hose and turn on water.
2. Point in the direction you want to spray, turn the sprayer control knob to the ON position, and spray.
3. To stop, turn the sprayer control knob to the OFF position and turn off the water.
4. When finished, relieve water pressure by turning the control knob back to ON until the line is depressurized, then turn back to OFF.
5. Disconnect the sprayer from the hose.